The former owner of this house was a HVAC contractor who appeared to own their own business. I’m pretty sure about this because I have found their business related items around the house. Since the house was foreclosed on, i assume they went out of business. I have no idea if they installed the forced air heating unit in this house, but if they did I can see why they went out of business.
To start, the heater is a Frasier-Johnson brand, which doesn’t appear to be made anymore and when it was, it was a low end brand. This heater has a EnergyGuide rating of 80, and the lowest scale is 78. Pretty much the least efficient you can get. The main problem is with the filter configuration. Two filters sit in a “V” configuration above the heating unit, but there is no easy way to install the filters.
There is no access panel in the duct work to put them in. The only way I can figure to put the filters in is to push them up from inside the heating unit. I have to reach about 12 inches inside the heater, reach around motors, electronics and whatever where I’m left with about an inch of space to get the filters inside. From there they have to balance precariously on a few pieces of metal in the “V” configuration, where I can’t actually see how they are setting without getting down on my knees with a flashlight to look up inside the duct work. They aren’t sealed against the duct work and one of them keeps falling out of place leaving huge gaps.
I’m looking at possible ways to cut up the duct work above the heater so I can access the filter area. Doesn’t look easy though.